Install

Install instructions 2004-2007


1. Loosen the nut on the bottom adjusters so that you can hand adjust them after you complete step 2. Remove the top two existing bolts located on the vehicle where the new grille with attach. Place the grille for a loose adjustment.  Adjust the 2 feet by hand until the bottom of the grille is even with a small gap across. Close hood and make sure its not too high or too low. Once correct, you can tighten the nut snug against the adjuster. Now the adjustment feet are set and you can proceed to installation. 


2. Remove the bottom bolt (10mm socket) in the center of the horizontal valance or thin body panel under where the grille will be located. use the long spacer and new bolt to install the bottom of the grille. Leave it a bit loose. Use the washer under the head of the bolt or the bolt may be too long.


3. Using the existing bolts, install grille and reuse bolts that you removed from step 1. The top two mounts will need about 2 washers behind them on each side to space the grille out properly, maybe less or more depending on your vehicle. The rubber seal should just cover the top edge of the grille so you cannot see the welds. 


4. Tighten the bottom center bolt and adjust in/out as needed. 


Install instructions 1998-2003


1. Remove the top two existing bolts located on the vehicle where the new grille with attach. 


2. Remove the bottom bolt (10mm socket) in the center of the horizontal valance or thin body panel under where the grille will be located. use the long spacer and new bolt to install the bottom of the grille. Leave it a bit loose. Use the washer under the head of the bolt or the bolt may be too long.


3. Using the existing bolts, install grille and reuse bolts that you removed from step 1. The top two mounts will need about 2 washers behind them on each side to space the grille out properly, maybe less or more depending on your vehicle. The rubber seal should just cover the top edge of the grille so you cannot see the welds.


4. Tighten the bottom center bolt and adjust in/out as needed.



Install instructions 80 series, including Lexus


1. Remove the horn bracket, relocate both horns side using existing bolts in reach of the wired horns. 

2. Loosen or remove the left side bolt on the horn bracket. Also, loosen or remove the bolt on the right side where the new grille will mount. Place grille for a test fit, check gaps around headlights, the grille should not touch the headlights. The top mounts will need washers  behind them on both sides approx 2-3 washers on each side. This will space the grille out to align properly with the headlights and hood. It also needs washers in this location, as there is a slight lip on the  lower part of the panel and the grille mounts will not seat properly. Once adjusted then tighten the bolts snug temporarily. 


3. The bottom mount will need a hole drilled, about 1/4”, mark in the center of the opening and remove the grille. 


4. Drill the hole and then install the grille, adjust as needed. 


  • Due to the age of thes vehicles, additional adjustments may be needed for proper alignment. Headlights, valances and other supports are sometimes inconsistent and need slight adjustments.